SpeedyBee F745 35A AIO Flight Controller (25.5mm)

The SpeedyBee F745 35A AIO is an F7 flight controller and 35A 4in1 ESC – all in one. Its ideal for use on 3.5″ to 5″ cinewhoops or long range quads with 25.5mm x 25.5mm mounting holes. The F745 AIO also features SpeedyBee app compatibility enabling full wireless programming on the go. The F745 AIO features compatibility with HD or analogue VTX (VBAT passthrough, make sure not to exceed the rating of the Air Unit) and includes analogue OSD, Barometer and blackbox logging.

Note: Make sure the AIO’s slightly bigger size can fit your own quad! The size of this AIO is 36.5(L)*36.5(W)*7.0(H)mm. We suggest you use this AIO on your 3.5″ to 5″ cinewhoops/long-range or lightweight quads.For quads below 3.5″,you should carefully check if your quad has enough room for this AIO.

Specifications:

– Product Name    SpeedyBee F745 35A BLS AIO
– Power Input    3S – 6S Lipo
– Mounting    25.5 x 25.5mm, 3mm hole diameter
– Dimension    36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above
– Weight    10.1g

FC Specifications:

– MCU: STM32F745
– IMU(Gyro): MPU6000
– USB Connection: Need to solder a USB TYPE-C module to D+,D-,GND pads.
– Barometer: BMP280
– OSD: Supported
– BLE Bluetooth: Supported. Used for parameter configuration
– Flash FC Firmware Wirelessly: Supported
– Download/Analyze Blackbox: Supported
– DJI Air Unit 6-pin Connector: Built-in.
– Flash(for BlackBox): 8MB
– Current Sensor: Supported. Scale=256
– BetaFlight Camera Control Pad: Yes(CC pad)
– 5V Output: 4 groups of 5V output. The total current load is 2.5A.
– 9V Output: None
– 3.3V Output: Supported. Up to 500mA current load.
– ESC Signal Pads: M1 – M4
– UART: Full UART * 4(UART1, UART2, UART3,UART4)
– ESC Telemetry UART: None
– I2C: Supported.
– LED Pad: Used for WS2812 LED
– Buzzer: BZ+ and BZ- pad used for 5V Buzzer
– BOOT Button: Used to enter DFU mode
– RSSI Input: Not supported
– SmartPort: Use any TX pad of UART for the SmartPort feature.
– Supported Flight Controller: BetaFlight(Default)
– Firmware Firmware Target Name: SPEEDYBEE F745AIO

ESC Specifications:

– Power Input: 3-6S LiPo
– Continuous Current: 35A * 4
– Burst Current: 45A(5S)
– ESC Protocol: DSHOT300/600
– Power Output: VBAT
– Current Sensor: Supported(Sacle=256)
– Firmware: BLHeli_S JH40

Includes:

1x SpeedyBee F745 35A AIO Flight Controller
Accessories